CLEAN GREEN

TECHNICAL PRODUCT BULLETIN #SW-44
USEPA, OIL PROGRAM CENTER
ORIGINAL LISTING DATE: AUGUST 5, 2010
"CLEAN GREEN"
 

I. NAME, BRAND, OR TRADEMARK
CLEAN GREEN
(aka, CLEANGREEN® PLANET WASH)
Type of Product: Surface Washing Agent
II. NAME, ADDRESS, AND TELEPHONE NUMBER OF MANUFACTURER/CONTACT
U.S. AG, LLC
P.O. Box 368
Luthersville, GA 30251
Phone: (770) 927-3206
Fax: (770) 927-3968
E-mail: unitedstatesag@yahoo.com
Web Site: http://www.unitedstatesag.org Exit
(Mr. Carl Schneider)
III. NAME, ADDRESS, AND TELEPHONE NUMBER OF PRIMARY DISTRIBUTORS
U.S. AG, LLC
56 N Main
Luthersville, GA 30251
Phone: (770) 927-3206
Fax: (770) 927-3968
E-mail: unitedstatesag@yahoo.com
Web Site: http://www.unitedstatesag.org Exit
(Mr. Carl Schneider)
IV. SPECIAL HANDLING AND WORKER PRECAUTIONS FOR STORAGE AND FIELD APPLICATION
1. Flammability: Non-flammable (DOT: Non-hazardous)
2. Ventilation: No special requirements.
3. Skin and eye contact; protective clothing; treatment in case of contact: No special equipment or clothing required, however, goggles are recommended. If eye or skin irritation occurs, flush with plenty of fresh water.
4.a. Maximum storage temperature: 120°F continuous, 140°F up to 5 days
4.b. Minimum storage temperature: 35°F
4.c. Optimum storage temperature range: 40°F to 120°F
4.d. Temperatures of phase separations and chemical changes: Stable
V. SHELF LIFE
5 years in sealed polydrums or totes (as delivered).
VI. RECOMMENDED APPLICATION PROCEDURE
1. Application Method: Product may be applied to any oil coated surface, such as beaches, equipment, rocks, etc. A variety of pumps or sprayers may be used for direct application to contaminates, back-pack, drum pumps, pick-up sprayers, etc.
2. Concentration/Application Rate: Where ever higher oil concentrations occur use approximately a 1:10 dilution ratio (product:water). Lightly soiled areas will require a 1:10 to 1:30 ratio.
3. Conditions for Use: Residue from surface washing should be collected and disposed of according to local, state, and federal regulations. The collection of residue can be determined on a site by site basis based on best practices of the area.
VII. TOXICITY AND EFFECTIVENESS
a. Toxicity:
Material Tested Species LC50 (ppm)
CLEAN GREEN Menidia beryllina
Mysidopsis bahia
136.10 96-hr
70.70 48-hr
No. 2 Fuel Oil Menidia beryllina
Mysidopsis bahia
3.35 96-hr
2.24 48-hr
CLEAN GREEN & No. 2 Fuel Oil (1:10) Menidia beryllina
Mysidopsis bahia
4.73 96-hr
2.24 48-hr
Reference Toxicant (SLS) Menidia beryllina
Mysidopsis bahia
12.25 96-hr
10.53 48-hr

b. Effectiveness
NA
VIII. MICROBIOLOGICAL ANALYSIS
NA
IX. PHYSICAL PROPERTIES
1. Flash Point: >93°C
2. Pour Point: +25°F
3. Viscosity: 3.72 @40°C
4. Specific Gravity: 1.0691 @70°F
5. pH: 9.9
6. Surface Active Agents: CONFIDENTIAL
7. Solvents: CONFIDENTIAL
8. Additives: CONFIDENTIAL
9. Solubility: Miscible in oil, water, and solvents
X. ANALYSIS FOR HEAVY METALS, CYANIDE, AND CHLORINATED HYDROCARBONS
Compound Concentration (ppm)
Arsenic 0.0265
Cadmium <0.005
Chromium 0.0985
Copper <0.0150
Lead <0.0100
Mercury 0.0005
Nickel <0.0250
Zinc 0.2455
Cyanide <0.300
Chlorinated Hydrocarbons <5.0

Top of Page