NATURAMA G3 A-5

TECHNICAL PRODUCT BULLETIN #SW-53
USEPA, OIL PROGRAM CENTER
ORIGINAL LISTING DATE: JANUARY 26, 2011
“NATURAMA G3 A-5”

I. NAME, BRAND, OR TRADEMARK
NATURAMA G3 A-5
Type of Product: Surface Washing Agent
II. NAME, ADDRESS, AND TELEPHONE NUMBER OF MANUFACTURER/CONTACT
Green Life Development, Inc.
5316 W. Charleston Boulevard
Las Vegas, NV 89146
Phone: (702) 966-1284
Mobile: (702) 355-5102
Fax: (702) 448-6977
E-mail: david@greenlifedevelopment.com
Website: www.greenlifedevelopment.com Exit
(Mr. David A. Levy)
Merlin-Tao Ltd.
65 Yigal Alon St. POB 91
Tel Aviv, Israel 67443
Phone: 972-3-562-8020
Fax: 972-3-562-8021
E-mail: asaf@merlin-tao.com
Web site: www.merlin-tao.com Exit
(Mr. Asaf Yari, CEO)
III. NAME, ADDRESS, AND TELEPHONE NUMBER OF PRIMARY DISTRIBUTORS
Green Life Development, Inc.
5112 W. Charleston Blvd., Suite C
Las Vegas, NV 89146
Phone: (702) 966-1284
Fax: (702) 448-6977
E-mail: info@greenuses.com
Web site: www.greenuses.com
(Mr. David A. Levy)
IV. SPECIAL HANDLING AND WORKER PRECAUTIONS FOR STORAGE AND FIELD APPLICATION
1. Flammability: Non-flammable (DOT: Non-hazardous)
2. Ventilation: No special requirements.
3. Skin and eye contact; protective clothing; treatment in case of contact: No special equipment or clothing is required; however, goggles are recommended. If eye or skin irritation occurs, flush with plenty of water.
4.a. Maximum storage temperature: 120°F continuous, 140°F up to 5 days
4.b. Minimum storage temperature: 35°F
4.c. Optimum storage temperature range: 40°F to 120°F
4.d. Temperatures of phase separations and chemical changes: Stable
V. SHELF LIFE
NATURAMA G3 A-5 has unlimited shelf life in sealed poly drums.
VI. RECOMMENDED APPLICATION PROCEDURE
1. Application Method: Product may be applied by any method (e.g., drum pump, pressurized spray applicator, brush, or aqueous wash tank), depending on the surface; and type and viscosity of the oil/contamination to be treated.
2. Concentration/Application Rate: The dilution ratio depends on the amount and type of contamination to be removed. For light contamination areas a 1:6 dilution ratio (product to fresh/salt water) with a 2-3 minutes wait. For heavier/thick/burnt contamination, the exact ratio should be determined by the field coordinator but a general starting point of 20-25% should remove most contamination (grease, burnt oil, diesel, tar, etc.) after a contact time of 10-15 minutes before rinsing with water/steam.
3. Conditions for Use: Cleanup residue must be collected and should be disposed of in accordance with local, state, and federal regulations. Where possible, the product/oil mixture can be recovered and processed using an oil separator system or a stagnant tank. A circulating wash tank fitted with an oil separator or filter system extends the life of NATURAMA G3 A-5 by weeks, greatly impacting the waste reduction.
VII. TOXICITY AND EFFECTIVENESS
a. Toxicity:
Material Tested Species LC50 (ppm)
NATURAMA G3 A-5 Menidia beryllina
Mysidopsis bahia
577.68 96-hr
482.97 48-hr
No. 2 Fuel Oil Menidia beryllina
Mysidopsis bahia
2.39 96-hr
0.32 48-hr
NATURAMA G3 A-5 &
No. 2 Fuel Oil (1:10)
Menidia beryllina
Mysidopsis bahia
3.68 96-hr
2.24 48-hr
Reference Toxicant (SLS) Menidia beryllina
Mysidopsis bahia
12.25 96-hr
12.08 48-hr

b. Effectiveness:
NA

VIII. MICROBIOLOGICAL ANALYSIS
NA
IX. PHYSICAL PROPERTIES
1. Flash Point: >93°C
2. Pour Point: +28°F
3. Viscosity: 1.3628 cst @ 40°C
4. Specific Gravity: 1.006 @60°F
5. pH: 8.39
6. Surface Active Agents: PROPRIETARY
7. Solvents: PROPRIETARY
8. Additives: None
9. Solubility: Miscible in oil, water, and solvents
X. ANALYSIS FOR HEAVY METALS, CYANIDE, AND CHLORINATED HYDROCARBONS
Compound Concentration (ppm)
Arsenic 0.0092
Cadmium <0.002
Chromium 0.0262
Copper <0.006
Lead 0.0062
Mercury 0.0005
Nickel <0.01
Zinc <0.0166
Cyanide 0.014
Chlorinated Hydrocarbons <26.30

Top of Page