You are here:
Sampling and Analysis Guidance
This page provides links to various guidance resources with information on sampling and analysis for volatile organic compounds (VOCs).
You will need Adobe Reader to view some of the files on this page. See EPA’s About PDF page to learn more.
The National Risk Management Research Laboratory (NRMRL) and National Exposure Research Laboratory (NERL) of EPA's Office of Research and Development (ORD) is conducting research and providing technical assistance to EPA program offices, regional offices, and states in the area of vapor intrusion. ORD's Research on Vapor Intrusion page can be found here.
SW-846 Manual – Test Methods for Evaluating Solid Waste, Physical/Chemical Methods: EPA's Office of Solid Waste's official compendium of analytical methods that have been evaluated and approved for use in complying with the RCRA regulations.
Method 8260C: Volatile Organic Compounds by Gas Chromatography/Mass Spectrometry (GC/MS) (Revision 3, August 2006) (PDF) (92 pp, 324 K)
Method for determining volatile organic compounds in a variety of solid waste matrices.
Media Specific Resources
Sampling and Analysis for VOCs in Soil and Groundwater
VOC Sampling and Analysis
EPA’s Technology Innovation Program website includes links to methods for sampling and analyzing soil and groundwater for VOCs including EPA’s Method 5035A, U.S. Army Corps of Engineers guidance and technical reports and ASTM Method D4547-98.
Composite Sampling for Soil VOC Analysis (PDF) (31 pp, 207 K)
Quality Assurance Project Plan Prepared by Lockheed Martin Environmental Services for the EPA’s National Exposure Research Laboratory (NERL) under Project LV470850 (4-70.85), October 1, 2004.
Groundwater Sampling Guidelines for Superfund and RCRA Project Managers (PDF) (53 pp, 631 KB) (OSWER EPA 542-S-02-001 May 2002)
This document provides a summary of recommended groundwater sampling procedures for a variety of chemicals including VOCs.
EPA Region 4 Groundwater Sampling (PDF) (32 pp, 534 K) (SESDPROC-301-R2, October 2011)
This document describes general and specific procedures, methods and considerations to be used and observed when collecting groundwater samples for field screening or laboratory analysis. It includes discussion of considerations for collecting groundwater samples for VOC analysis.
Sampling Soil Gas
If buildings are present in the area of concern, the most relevant location to collect soil gas measurements is directly below the building foundation ("sub-slab"). If buildings are not currently present in the area of concern, then the most relevant location to collect soil gas measurements is in subsurface soil at a depth that is similar to the depth of a potential future foundation.
Soil-Gas Measurement (PDF) (3 pp, 386 K)
A fact sheet developed by EPA’s National Exposure Research Laboratory.
EPA’s Comparison of Three Soil-Gas Sampling Techniques: traditional dedicated vapor probes, a truck-mounted direct-push Geoprobe® post-run-tubing (PRT) system, and the hand-held rotary-hammer AMS gas vapor probe (GVP) kit:
- Short article: EPA Compares Three Soil-Gas Sampling Systems for Vapor Intrusion Investigations
- EPA. 2006. Comparison of Geoprobe® PRT and AMS GVP Soil-Gas Sampling Systems with Dedicated Vapor Probes in Sandy Soils at the Raymark Superfund Site. November 2006 (ORD EPA/600/R-06/111 November 2006)
Sub-Slab Air Permeability Testing and Air Sampling Using TO-17 (PDF) (50 pp, 1.2 MB)
Presentation by the Office of Research and Development (ORD) at the U.S. EPA Technical Support Project Semi-Annual Meeting in Denver, Colo. in June 2002.
Sampling and Analysis of Indoor Air
In many cases, direct measurement of concentration levels for the exposure medium of potential concern has less uncertainty than predictions of concentration levels based on mathematical fate and transport models. In the case of indoor air, the direct measurement approach is complicated by that fact that there are other sources of VOCs in indoor air besides intrusion from soil or groundwater, so interpretation of measured values may require a careful comparison of "background" levels. This page provides more information on evaluating background sources of VOCs in indoor air.
EPA Region 8’s recommended approach for the collection of indoor air samples.
Colorado’s Guidance for Analysis of Indoor Air Samples (April 2000) (PDF) (9 pages, 30 K)
Minimum acceptable requirements recommended by the Colorado Department of Public Health and Environment for the analysis of VOCs in indoor air by GC/MS.
Sampling Ambient Air
When sampling indoor air as part of a vapor intrusion study, outdoor ambient air samples should usually be collected as well to characterize site-specific outdoor air background conditions.
A set of 17 peer-reviewed, standardized methods for the determination of volatile, semi-volatile, and selected toxic organic pollutants in air are available here and include the following:
- Compendium Method TO-15: Determination of Volatile Organic Compounds (VOCs) in Air Collected in Specially-Prepared Canisters and Analyzed by Gas Chromatography/Mass Spectrometry (GC/MS) (PDF) (67 pages, 890 K)
Sampling and analytical procedures for the measurement of VOCs, applicable to most conditions encountered in the collection of ambient air samples into canisters.
- Compendium Method TO-17: Determination of Volatile Organic Compounds in Ambient Air Using Active Sampling Onto Sorbent Tubes (PDF) (53 pages, 309 K)
Sorbent tube monitoring method for the determination of VOCs in ambient air at 0.5 to 25 parts per billion (ppbv) concentration levels.
- Supplement to EPA Compendium Method TO-15 – Reduction of Method Detection Limits to Meet Vapor Intrusion Monitoring Needs (April 2004, revised June 2006)
Citation for guidance document on reducing the method detection limit (MDL) for 1,1-dichloroethene (1,1-DCE) and for other VOCs from 0.5 parts per billion by volume (ppbv) to much lower concentrations.